http://www.k-wave.org/forum/topic/speaker-decoding Support for the k-Wave MATLAB toolbox en-US Wed, 13 May 2026 12:08:13 +0000 http://bbpress.org/?v=1.0.2 q http://www.k-wave.org/forum/search.php http://www.k-wave.org/forum/topic/speaker-decoding#post-5633 Wed, 10 Aug 2016 17:36:31 +0000 Bradley Treeby 5633@http://www.k-wave.org/forum/ <p>Hi nickbruno,</p> <p>If it's a single file, you can just copy and paste your code to the forum (it's not possible to upload files). </p> <p>Regarding the format of <code>sensor_data</code>, the best place to start is the examples (these are accessible under the k-Wave heading in the MATLAB help browser), and the k-Wave manual.</p> <p>One thing to check is that your source only contains frequencies supported by the computational grid. This can be enforced using the <code>filterTimeSeries</code> function.</p> <p>Brad. </p> http://www.k-wave.org/forum/topic/speaker-decoding#post-5621 Wed, 03 Aug 2016 20:03:32 +0000 nickbruno 5621@http://www.k-wave.org/forum/ <p>Hi all,</p> <p>I am trying to write a code where I simulate playing a pulsed 1kHz tone from 1 or more speakers out of an entire array (3x3) at 5 different distances. I then have a code where I can input the "actual speaker" that is making the noise and I can see the error between what speaker(s) was calculated and what speaker(s) was actually being used. Ultimately I want to show that error increases as distance from the sound source increases. Does anyone have any general advice on this? I have some code written, and it seems to be running well, but my sensor_data is not of the form that I would like, and I'm not sure why..</p> <p>I am new to here so I am not sure how to post my code appropriately, but I would be glad to do so with some instruction.</p> <p>Best </p>