http://www.k-wave.org/forum/topic/ultrasound-transducer-as-sensor Support for the k-Wave MATLAB toolbox en-US Wed, 13 May 2026 00:28:59 +0000 http://bbpress.org/?v=1.0.2 q http://www.k-wave.org/forum/search.php http://www.k-wave.org/forum/topic/ultrasound-transducer-as-sensor#post-6576 Wed, 12 Sep 2018 21:10:30 +0000 Seneca 6576@http://www.k-wave.org/forum/ <p>Dear all,</p> <p>I found the answer here: </p> <p><a href="http://www.k-wave.org/forum/topic/3d-simulations-output-with-gpu" rel="nofollow">http://www.k-wave.org/forum/topic/3d-simulations-output-with-gpu</a></p> <p>Best regards </p> http://www.k-wave.org/forum/topic/ultrasound-transducer-as-sensor#post-6575 Wed, 05 Sep 2018 16:01:07 +0000 Seneca 6575@http://www.k-wave.org/forum/ <p>Dear all,</p> <p>I am performing some simulations using k-wave. Normally I used sensor instead of ultrasound transducer array.<br /> If I run the 'example_us_transducer_as_sensor' my final data is always: </p> <p>sensor_data = number_of_activeElements*time_vector; Which is fine for me, because I can visualize each single line in function of time.</p> <p>Nevertheless, if I perform the simulation saving in the GPU, I do not have the same output as sensor_data. I obtain something like:</p> <p>data_sensor = X*number_of_activeElements*time_vector; if I use 10 active elements I have something like: sensor_data = 120*time_vector. Where X in this case is 12.</p> <p>Is it possible to run a simulation in the GPU and only have the pressure recorded in the active elements of the sensor?</p> <p>Best </p>